Temperature Gauge
Disconnect connector from temperature sender. Connect the wire from the sender in turn to each of the resistors specified in table and ground resistor to body. Turn ignition on, and confirm that gauge readings are in the correct segment. If not, replace gauge.
TEMPERATURE GAUGE RESISTANCE CHECK
| Number of Segments Lit | Resistor Used |
|---|---|
| 1 | 178 or More Ohms |
| 3 | 121-147 Ohms |
| 5 | 33-89 Ohms |
| 7 | 21-24 Ohms |
| 9 | Less Than 18 Ohms |