Fuel Gauge
Remove connector from fuel gauge. Connect the "Y" wire from the fuel gauge connector in turn to each of the resistors specified in the table and ground resistor to body. SeeFigure . Turn ignition on to confirm gauge readings are in the correct segment. If not, replace gauge.
FUEL GAUGE RESISTANCE CHECK
| Number of Segments Lit | Resistor Used |
|---|---|
| 1 | 96 or More Ohms |
| 3 | 56-72 Ohms |
| 5 | 32-40 Ohms |
| 7 | 20-28 Ohms |
| 9 | 8-16 Ohms |
| 10 | Less Than 8 Ohms |