LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1982 >> GLC Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Column Switches >> MAZDA >> Removal & Installation >> Steering Wheel & Combination Switch >> Removal

Steering Wheel & Combination Switch: Removal

  1. Disconnect battery ground cable. Pull off horn cap. Place front wheels in straight-ahead position. Index mark column shaft and steering wheel.
  2. Remove steering column shrouding. Disconnect electrical connectors. To disconnect electrical connections on RX7, remove air duct at base of steering column.
  3. On all models, remove steering shaft stop ring, cancel cam and spring. Remove retaining screws and combination switch assembly.
    NOTE: Wiper switch can be removed with combination switch or separated from it.
    Fig 1: Typical Mazda Steering Wheel Assembly
    G09361903Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals