LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1981 >> B2000 Base >> Repair and Diagnosis (Single Page) >> Steering >> Manual Steering >> Steering Gears & Linkage MAZDA Recirculating Ball >> Removal & Installation >> Steering Gear >> Removal (626 & RX7)

Removal (626 & RX7)

  1. Disconnect negative battery cable. Remove steering wheel and switches. See Mazda under  STEERING WHEEL & COLUMN SWITCHES   in this Section.  Remove bolts holding column to dash. Tape holes to retain lubricant. Remove air duct.
  2. Raise and support front of vehicle. Disconnect pitman arm and center link. Remove nuts and bolts retaining steering gear housing to body. Remove under cover, engine mount and stabilizer bar (626 only). Remove hood (RX7 only). Remove steering gear assembly from vehicle.
scientia non olet · About LEMON Manuals