Brake Shoes &/Or Pads: Remove & Replace
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,w/Rear Disc Brakes | 1.8 | B | ||
| All,w/Rear Drum Brakes | 2.2 | B | ||
| Front | 1.0 | B | ||
| Rear,w/Disc Brakes | 1.0 | B | ||
| Rear,w/Drum Brakes | 1.4 | B | ||
| Combination Procedure: CALIPER: Overhaul: | ||||
| One,w/ABS | Includes: Bleed Brakes. | 0.9 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One,w/o ABS | Includes: Bleed Brakes. | 0.3 | B | |
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: NOTE: This operation does not apply to front rotors on FWD vehicles or rear rotors on RWD vehicles. If on vehicle refinishing is not possible use appropriate repair operation. | ||||
| Front,Each | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Front | Includes: Repack Wheel Bearings. | 0.4 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| 0.6 | B | |||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| RWD, Front,Both Sides | 0.8 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| RWD, Front,Each Side | 0.5 | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| One,Off Vehicle,w/o ABS | 0.4 | B | ||
| One,On Vehicle,w/o ABS | 0.3 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One,w/o ABS | 0.3 | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| RWD, Rear,Each Side | 0.6 | B | ||