Engine Removal
- Disconnect battery, remove hood, drain cooling system and remove radiator. Disconnect heater hoses at heater unit. Disconnect cables from carburetors.
- Disconnect oil pressure gauge pipes and oil cooler lines from connections at engine. If tachometer is of mechanical drive type, disconnect cable and reduction gear assembly from rear of generator.
- Disconnect electrical connections from generator, coil and distributor. Remove distributor cap complete with spark plug wires. Remove starter cable from front end of starter and disconnect fuel line at fuel pump. Release clamp which holds exhaust pipe to exhaust manifold and lower exhaust pipe.
- Remove fuel filter bowl and starter motor. Support transmission with a jack and remove transmission-to-engine bolts. Disconnect engine motor mounts and hoist engine from vehicle leaving transmission in place.