LEMON Manuals: Even more car manuals for everyone
Home >> MG >> 1968 >> MGB Base, Not Available Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> S.U. Hp & AUF 300, 301, 303, 306 Electric Fuel Pumps >> Overhaul >> Coil Housing To Body Reassembly (Model Hp) >> Notes

Coil Housing To Body Reassembly (Model Hp): Notes

  1. Position the sandwich plate joint gasket on the face of the body and line up the holes. Place the sandwich plate on the gasket and again line up the holes.
  2. Place the coil housing on the body and sandwich plate with the connections at the top and the filter at the bottom. with the two cast lugs on the coil housing at the bottom, insert the six screws and tighten finger tight. Install the ground screw and connector.
  3. Remove the roller retaining fork. Check to see that the rollers are retained in position. Tighten the screws in sequence as they are diametrically opposite each other.
scientia non olet · About LEMON Manuals