LEMON Manuals: Even more car manuals for everyone
Home >> MG >> 1968 >> MGB Base, Not Available Trans >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Mg Engines - (4 Cylinder) >> 1963-73 MGB & MGB/Gt 4 Cylinder >> Camshaft Center Bearing Reaming

Camshaft Center Bearing Reaming

  1. Insert suitable pilots (18G 123T & 123AD) in front and rear bearings. Pass arbor through pilot in front bearing and place cutter for center bearing on arbor. Push arbor through center bearing and pilot located in rear bearing.
  2. Hold cutter and pilots in position, make sure locating pin of cutter engages correct numbered hole in arbor. Ream bearing, release cutter and remove arbor.
scientia non olet · About LEMON Manuals