Turbocharger Coolant Supply Tube LH: Installation

Lubricate the rubber gasket and tube with clean engine coolant. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
Install a new turbocharger coolant supply tube O-ring seals. Lubricate the new O-ring seal with clean engine coolant. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: Use brake cleaner and a nylon brush to clean. Do not use a metal brush, damage to sealing area will result in leaks.
1. Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to engine O-ring bore and the turbocharger tube to turbocharger O-ring bore. Inspect the area for deep scratches and gouges. Install new components if needed.
2. Install the turbocharger coolant supply tube, then install and tighten the bolts.
  Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
  
  Torque: 89 lb.in (10 Nm)
Courtesy of FORD MOTOR COMPANY
Install the new turbocharger oil return tube-to-engine block gasket.

Courtesy of FORD MOTOR COMPANY
Install a new turbocharger oil return tube O-ring seal, then lubricate with clean engine oil. Refer to: Specifications .

Courtesy of FORD MOTOR COMPANY
NOTE: Do not use a metal brush, damage to sealing area will result in leaks.
- Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger O-ring bore. Inspect the area for deep scratches and gouges.
1. Install the turbocharger oil return tube, then install and tighten the turbocharger oil return tube bolts.
  Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
  
  Torque: 89 lb.in (10 Nm)
Courtesy of FORD MOTOR COMPANY
Install the wire harness bracket, then install and tighten the bolt.
Torque: 106 lb.in (12 Nm)

Courtesy of FORD MOTOR COMPANY
Install the starter motor. Refer to: Starter Motor - 3.0L EcoBoost, .
Install the left engine mount. Refer to: Engine Mount LH - 3.0L EcoBoost, .
Connect the battery. Refer to: Battery Disconnect and Connect .
Fill the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding - 3.0L EcoBoost, . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding - 3.0L EcoBoost - Hybrid (BQ), .
Check and top off the engine oil level as needed. Refer to: Specifications - 3.0L EcoBoost, .