Pinpoint Test G: The LH (Left-Hand) - RH (Right-Hand) Turn/Hazard Signal Display Is Inoperative

Normal Operation and Fault Conditions
See LH And RH Turn Signal. REFER to: Head Up Display (HUD) - System Operation and Component Description .

Possible Sources
- Communication concern
- BCM concern
- GWM concern
- HUD module

G1 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Body Control Module (BCM) .

No GO to G2

G2 PERFORM THE HUD (HEAD UP DISPLAY) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the HUD module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the HUD module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to DTC Chart: HUD Module in This Service Information.

No GO to G3

G3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Communications Network .

No INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module .