Pinpoint Test Ag : U0300: 57, U3000: 44, U3000: 45, U3000: 46 Or U3000: 49
- Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PAM U0300: 57 Internal Control Module Software Incompatibility: Invalid/Incompatible Software Component Sets in the PAM when invalid or incompatible software is detected. PAM U3000: 44 Control Module: Data Memory Failure Sets in the PAM when the PAM fails the read write check. PAM U3000: 45 Control Module: Program Memory Failure Sets in the PAM when there is a ROM memory checksum failure. PAM U3000: 46 Control Module: Calibration/Parameter Memory Failure Sets in the PAM when the PAM detects a read write failure in the EEPROM. PAM U3000: 49 Control Module: Internal Electronic Failure Sets in the PAM when module detects an internal failure. Possible Sources
- PAM
- AG1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE PAM (PARKING ASSIST CONTROL MODULE) SELF-TEST
- Ignition ON.
- Using the diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).
- Wait 10 seconds.
- Using the diagnostic scan tool, perform the PAM self-test.
Is DTC U0300: 57, U3000: 44 U3000;45, U300046 or U3000: 49 retrieved?
Yes INSTALL a new PAM, REFER to: Parking Assist Control Module (PAM) . No The system is operating correctly at this time.