Pinpoint Test D : The Rear Parking Aid Camera Is Inoperative: Notes
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
IPMB DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B14A4: 11 | Camera Power: Circuit Short To Ground | A continuous and on-demand DTC that sets in the IPMB when an excessive current draw is detected on the rear parking aid camera coaxial cable. |
| B115E: 31 | Camera Module: No Signal | A continuous and on-demand DTC that sets in the IPMB when expected video signals are not received from the rear parking aid camera. |
Possible Causes
- Coaxial cable
- Communication network concern
- TR input concern
- Vehicle speed input concern
- Rear parking aid camera
- FDIM
- IPMB
- APIM
Visual Inspection and Diagnostic Pre-Checks
- Verify the liftgate is fully closed.
NOTE:
Before disconnecting the parking aid camera, verify that the connectors are properly seated and latched.