Image Display
The 360 degree view camera system is capable of generating several different views using the front, rear, LH side, RH side, and the IPMB. The IPMB processes the video signals from the cameras and generates the appropriate views that are displayed on the FDIM. The views that are displayed are determined by the transmission gear selector position.
When the ignition is ON and reverse gear is selected, the rear camera views are shown on the FDIM. The Rear 360 + Normal view is shown first. Subsequent presses of the camera selection switch or on-screen buttons when reverse gear is selected allow the driver to cycle through the following rear camera views:
| View order | View name | Description |
|---|---|---|
| 1 | Rear 360 + Normal | Contains the normal rear camera view, shown next to a 360 degree camera view. |
| 2 | Rear Normal | Provides an image of what is directly behind the vehicle. |
| 3 | Rear Split View | Provides an extended wide angle image of what is behind the vehicle. |
When the ignition is ON and any gear except reverse is selected, the front camera and 360 degree views are shown on the FDIM when the camera selection switch is pressed. The front images are available until the vehicle speed reaches 10 km/h (6 mph). The Front 360 + Normal view is shown first. Subsequent presses of the camera selection switch allow the driver to cycle through the following front camera views:
| View order | View name | Description |
|---|---|---|
| 1 | Front 360 + Normal | Contains the normal front camera view, shown next to a 360 degree camera view. |
| 2 | Front Normal | Provides an image of what is directly in front of the vehicle. |
| 3 | Front Split View | Provides an extended wide angle image is what is in front of the vehicle. |
To enable the front or rear camera displays, the IPMB monitors the camera selection switch or on-screen button status from the APIM, gear position and vehicle speed messages. The PCM sends the gear position and vehicle speed messages to the GWM through the HS-CAN1 and the APIM sends the on-screen camera selection button status message to the GWM through the HS-CAN3. The GWM then sends the messages to the IPMB via HS-CAN2.
All camera views are generated by the IPMB, using the video signals from one or more of the cameras. The video signals are sent from the cameras to the IPMB through coaxial cables. The IPMB processes the image(s) from the cameras and sends a single image with the desired view to the APIM.