Symptom Chart: Glass, Frames and Mechanisms
Diagnostics in this service information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Symptom Chart
| Condition | Possible Sources | Actions |
|---|---|---|
| All power windows are inoperative from the driver door window control switch | Wiring, terminals or connectors Driver door window control switch DDM |
DIAGNOSE any related DDM Diagnostic Trouble Codes (DTCs) first. REFER to the DTC Chart: Driver Door Module (DDM) If there are no related Diagnostic Trouble Codes (DTCs) present, INSTALL a new driver door window control switch. REFER to: Driver Door Window Control Switch . |
| Both rear passenger power windows only operate from the master window control switch | Lock-out switch in the LOCK position Driver door window control switch |
DIAGNOSE any related DDM Diagnostic Trouble Codes (DTCs) first. REFER to the DTC Chart: Driver Door Module (DDM) . If there are no related Diagnostic Trouble Codes (DTCs) present, INSTALL a new driver door window control switch. REFER to: Driver Door Window Control Switch . |
| A single power window is inoperative/does not operate correctly -LH front | Refer to the Pinpoint Test | GO to Pinpoint Test C |
| A single power window is inoperative/does not operate correctly - RH front | Refer to the Pinpoint Test | GO to Pinpoint Test D |
| A single power window is inoperative/does not operate correctly - LH rear | Refer to the Pinpoint Test | GO to Pinpoint Test F |
| A single power window is inoperative/does not operate correctly - RH rear | Refer to the Pinpoint Test | GO to Pinpoint Test G |
| The one-touch up/down feature is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test E |
| The global open/close function is inoperative | RKE transmitter concern Door window regulator motor not initialized |
VERIFY the RKE lock/unlock function operates correctly using all of the RKE transmitters. REFER to: Locks, Latches and Entry Systems
.
to diagnose any inoperative RKE transmitter(s). INITIALIZE the inoperative door window regulator motor(s). REFER to: Power Door Window Initialization . |
| The defrost system is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test A |
| The defrost system does not shut off automatically | Refer to the Pinpoint Test | GO to Pinpoint Test B |