DTC Chart: HCM
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| DTC | Description | Action |
|---|---|---|
| C1A03:29 | Left Front Height Sensor: Signal Invalid | GO to Pinpoint Test L |
| C1A05:29 | Left Rear Height Sensor: Signal Invalid | GO to Pinpoint Test L |
| B103C:01 | Left Headlamp Control: General Electrical Failure | GO to Pinpoint Test M |
| B103C:55 | Left Headlamp Control: Not Configured | GO to Pinpoint Test M |
| B103C:96 | Left Headlamp Control: Component Internal Failure | GO to Pinpoint Test M |
| B103D:01 | Right Headlamp Control: General Electrical Failure | GO to Pinpoint Test M |
| B103D:55 | Right Headlamp Control: Not Configured | GO to Pinpoint Test M |
| B103D:96 | Right Headlamp Control: Component Internal Failure | GO to Pinpoint Test M |
| B1041:54 | Levelling Control: Missing Calibration | GO to Pinpoint Test N |
| B1087:00 | LIN Bus "A": No Sub Type Information | GO to Pinpoint Test K |
| B1088:00 | LIN Bus "B": No Sub Type Information | GO to Pinpoint Test K |
| B14D9:92 | Left Headlamp Light Distribution Actuator: Performance or Incorrect Operation | GO to Pinpoint Test K |
| B14DA:92 | Right Headlamp Light Distribution Actuator: Performance or Incorrect Operation | GO to Pinpoint Test K |
| U0100:00 | Lost Communication With ECM/PCM "A": No Sub Type Information | GO to Pinpoint Test O |
| U0121:00 | Lost Communication With Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to Pinpoint Test P |
| U0122:00 | Lost Communication With Vehicle Dynamics Control Module | GO to Pinpoint Test U |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test S |
| U0151:00 | Lost Communication With Restraints Control Module: No Sub Type Information | GO to Pinpoint Test T |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module | GO to Pinpoint Test V |
| U0212:00 | Lost Communication With Steering Column Control Module: No Sub Type Information | GO to Pinpoint Test Q |
| U023A:00 | Lost Communication With Image Processing Module A: No Sub Type Information | GO to Pinpoint Test R |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test W |
| U0401:00 | Invalid Data Received from ECM/PCM A: No Sub Type Information | GO to Pinpoint Test Z |
| U0415:00 | Invalid Data Received From Anti-Lock Brake System (ABS) Control Module "A": No Sub Type Information | GO to Pinpoint Test Z |
| U0416:00 | Invalid Data Received From Vehicle Dynamics Control Module | GO to Pinpoint Test Z |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | GO to Pinpoint Test Z |
| U0429:00 | Invalid Data received from Steering Column Control Module: No Sub Type Information | GO to Pinpoint Test Z |
| U0452:00 | Invalid Data Received From Restraints Control Module: No Sub Type Information | GO to Pinpoint Test Z |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | GO to Pinpoint Test X |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | GO to Pinpoint Test X |
| U3000:49 | Control Module: Internal Electronic Failure | GO to Pinpoint Test Y |