Pinpoint Test AF : U2024: 00, U2100: 00 Or U2101: 00
- Normal Operation and Fault Conditions
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PAM U2024: 41 Control Module Cal-Config Data: General Checksum Failure Sets in the PAM due to check sum error. PAM U2100: 00 Initial Configuration Not Complete: No Sub Type Information Sets in the PAM due to incomplete or incorrect PMI procedures. PAM U2101: 00 Control Module Configuration Incompatible: No Sub Type Information Sets in the PAM due to incomplete or incorrect PMI procedures. Possible Sources
- PAM
- AF1 CHECK VEHICLE HISTORY FOR RECENT SERVICE ACTIONS
- Check the vehicle history for any recent service actions related to the PAM.
Have any service actions been performed?
Yes REPEAT the PMI as directed by the diagnostic scan tool. No GO to AF2 - AF2 RECONFIGURE THE MODULE
- Ignition ON.
- Using the diagnostic scan tool, perform the PMI as directed by the diagnostic scan tool.
- Verify that the PAM functions correctly.
Does the PAM functions correctly?
Yes The system is operating correctly at this time. The concern may have been caused by incomplete or incorrect PMI procedure. No If the PAM fails to retain configuration data. INSTALL a new PAM, REFER to: Parking Assist Control Module (PAM) .