Pinpoint Test J : The Airbag Warning RTT (RECONFIGURABLE Telltale) Indicator Is Never Or Always On

Normal Operation and Fault Conditions
See Airbag Warning. REFER to: Instrument Panel Cluster (IPC) - System Operation and Component Description .

If the airbag warning indicator request message is missing for less than 5 seconds, the IPC defaults the airbag warning RTT indicator to its last indication state (on or off), based upon the last message received.

If the airbag warning indicator request message is missing for 5 seconds or longer, the IPC defaults the airbag warning RTT indicator on.

Possible Sources
- Communication concern
- SRS
- GWM
- IPC

J1 CHECK THE MESSAGE CENTER OPERATION
- Ignition ON.
- Close all doors, liftgate and the hood.
- Clear all message center warnings by pressing the OK button for each warning present.
- Monitor the door ajar RTT warning indicator.
- Open the driver door.
- Clear the message center popup warning.
- Monitor the door ajar RTT warning indicator.
Is the door ajar RTT warning indicator off with the door closed, and on with the door open?

Yes GO to J2

No GO to Pinpoint Test A

J2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to the IPC DTC Chart. Refer to Diagnostic Trouble Code (DTC) Chart

No GO to J3

J3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	REFER to: Communications Network .

No	If the airbag warning indicator is never on, the system is operating correctly. If the airbag warning indicator is always on, DIAGNOSE the SRS. REFER to: Airbag Supplemental Restraint System (SRS) .