Pinpoint Test By : The Parking Brake Warning Chime Is Inoperative
- Normal Operation and Fault Conditions
See Parking Brake Warning Chime. REFER to: Warning Chimes - System Operation and Component Description .
Possible Sources
- Brake warning indication concern
- Communication concern
- BCM
- GWM
- IPC
Visual Inspection and Pre-checks
- Check the operation of the parking brake warning chime with the vehicle moving at least 10 km/h (6.2 mph) and the parking brake slightly applied (just enough to turn the brake warning indicator on without damaging the rear brakes).
- BY1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver seatbelt.
- Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?
Yes GO to BY2 No GO to Pinpoint Test CB - BY2 CHECK THE BRAKE WARNING INDICATOR FOR CORRECT OPERATION
- Apply the parking brake.
- Observe the brake warning indicator.
Does the brake warning indicator illuminate?
Yes GO to BY3 No GO to Pinpoint Test P - BY3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the IPC DTC Chart. Refer to Diagnostic Trouble Code (DTC) Chart No GO to BY4 - BY4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No DIAGNOSE all BCM Diagnostic Trouble Codes (DTCs). REFER to: Body Control Module (BCM) .