Pinpoint Test AZ : The Fuel Door Release Chime Is Inoperative
- Normal Operation and Fault Conditions
See Fuel Door Release Chime. REFER to: Warning Chimes - System Operation and Component Description .
Possible Sources
- Communication concern
- PCM concern
- GWM
- IPC
- AZ1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver seatbelt.
- Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?
Yes GO to AZ2 No GO to Pinpoint Test AC - AZ2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the IPC DTC Chart. Refer to Diagnostic Trouble Code (DTC) Chart No GO to AZ3 - AZ3 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the PCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to the appropriate Electronic Engine Controls article. No GO to AZ4 - AZ4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No DIAGNOSE a fuel system concern. REFER to the appropriate Fuel System article.