Pinpoint Test I : The Transmission Gear Display Indication Is Inoperative
- Normal Operation and Fault Conditions
See Transmission Gear Display. REFER to: Head Up Display (HUD) - System Operation and Component Description .
Possible Sources
- Communication concern
- PCM concern
- GWM concern
- HUD module
- I1 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) KOEO (KEY ON, ENGINE OFF) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the PCMKOEO self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Electronic Engine Controls . No GO to I2 - I2 PERFORM THE HUD (HEAD UP DISPLAY) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the HUD module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the HUD module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: HUD Module in this information. Refer to Diagnostic Trouble Code (DTC) Chart No GO to I3 - I3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module .