Pinpoint Test G : The LH (Left-Hand) - RH (Right-Hand) Turn/Hazard Signal Display Is Inoperative
- Normal Operation and Fault Conditions
See LH And RH Turn Signal. REFER to: Head Up Display (HUD) - System Operation and Component Description .
Possible Sources
- Communication concern
- BCM concern
- GWM concern
- HUD module
- G1 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Body Control Module (BCM) . No GO to G2 - G2 PERFORM THE HUD (HEAD UP DISPLAY) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the HUD module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the HUD module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: HUD Module in this information. Refer to Diagnostic Trouble Code (DTC) Chart No GO to G3 - G3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module .