Pinpoint Test C : The BLIS (Blind Spot Information System) / CTA (Cross Traffic Alert) Indication Does Not Display
- Normal Operation and Fault Conditions
See BLIS/ CTA. REFER to: Head Up Display (HUD) - System Operation and Component Description .
Possible Sources
- Communication concern
- SODL concern
- SODR concern
- HUD module
- C1 PERFORM THE HUD (HEAD UP DISPLAY) MODULE SELF-TEST
- Ignition ON.
- Using a diagnostic scan tool, perform the HUD module self-test.
- Check for recorded Diagnostic Trouble Codes (DTCs) from the HUD module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to DTC Chart: HUD Module in this information. Refer to Diagnostic Trouble Code (DTC) Chart No GO to C2 - C2 PERFORM THE SODL (SIDE OBSTACLE DETECTION CONTROL MODULE LH) AND SODR (SIDE OBSTACLE DETECTION CONTROL MODULE RH) SELF-TESTS
- Using a diagnostic scan tool, perform the SODL and SODR self-tests.
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: BLIND SPOT INFORMATION SYSTEM No GO to C3 - C3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CM DTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?
Yes REFER to: Communications Network . No DIAGNOSE the Blind Spot Information System (BLIS). REFER to: BLIND SPOT INFORMATION SYSTEM