Pinpoint Test AU : B1492:68
- Normal Operation and Fault Conditions
This DTC is set when a fuel cutoff event has occurred and cutoff was requested by the RCM via the ENS (Event Notification System) and/or HS-CAN. Fault is cleared when and EventComplete message is received from the PCM.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition RCM B1492:68 Fuel Cutoff Event: Event Information This DTC sets when the RCM has requested a fuel shutoff event and has not received an Event Complete message from the PCM. Possible Sources
- A crash has occurred
- Fuel system damage
- NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- AU1 RESET THE ENS (EVENT NOTIFICATION SYSTEM)
- Inspect the fuel system for damage.
- Ignition OFF.NOTE: Use the following steps to reset the ENS (Event Notification System). The steps must be completed within 5 seconds.
- Ignition ON.
- Wait 10 seconds
- Ignition OFF.
- Ignition ON.
- Wait 10 seconds
Were any fuel system concerns found?
Yes REPAIR as necessary. GO to AU2 No GO to AU2 - AU2 CHECK FOR ADDITIONAL SRS (SUPPLEMENTAL RESTRAINT SYSTEM) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
-
NOTE: When selecting Restraints from the Self Test menu, DTCs are retrieved from the RCM and OCSM.
Using a diagnostic scan tool, perform
Restraints self-test.
Are any RCM or OCSM Diagnostic Trouble Codes (DTCs) retrieved on-demand during self-test?
Yes Do not clear any Diagnostic Trouble Codes (DTCs) until all Diagnostic Trouble Codes (DTCs) have been resolved. DIAGNOSE and REPAIR the SRS Diagnostic Trouble Codes (DTCs). REFER to Diagnostic Trouble Code (DTC) Chart . No The repair is complete. RETURN the vehicle to the customer.