Instrument Panel Center Finish Panel: Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Release the clips and remove the center finish panel.
   • Disconnect the electrical connector. Use the General Equipment: Interior Trim Remover

   Courtesy of FORD MOTOR COMPANY

2. Remove the bolts and the shifter module.
   • Disconnect the electrical connector.

   Courtesy of FORD MOTOR COMPANY

3. Release the clips and remove the FDIM rear cover. Use the General Equipment: Interior Trim Remover

   Courtesy of FORD MOTOR COMPANY

4. Remove the center vent trim panel.

   Courtesy of FORD MOTOR COMPANY

5. Remove the center vent and disconnect the electrical connector.

   Courtesy of FORD MOTOR COMPANY

6. Remove the bolts and the FDIM.
   • Disconnect the electrical connector.

     Torque: 22 lb.in (2.5 Nm)

   Courtesy of FORD MOTOR COMPANY

7. Release the clips and remove the upper RH instrument panel finish panel.

   Courtesy of FORD MOTOR COMPANY

8. Remove the bolts and the instrument panel center finish panel.
   • Disconnect the electrical connectors.

Courtesy of FORD MOTOR COMPANY