Transmission Fluid Exchange
WARNING: This page is about a different variant/trim than selected.
Materials
| Name | Specification |
|---|---|
| Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV | WSS-M2C949-A, MERCON® ULV |
Connect
- With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
- Use the Fluid Exchanger to change the fluid.
Material
: Motorcraft® MERCON® ULV Automatic Transmission Fluid / XT-12-QULV (WSS-M2C949-A,) (MERCON® ULV)
- Connect the Fluid Exchanger to the transmission fluid cooler tube after the transmission fluid cooler on the return tube. This will help remove any foreign material trapped in the transmission fluid coolers. For location of the transmission fluid cooler tubes. Refer to: Transmission Cooling - Component Location .
- Perform the transmission fluid exchange using the Fluid Exchanger. Follow the manufacturer's instructions included with the machine.
- Once the transmission fluid exchange is completed, disconnect the Fluid Exchanger. Reconnect any disconnected transmission fluid cooler tubes.
- Check the transmission fluid level. Refer to: Transmission Fluid Level Check .