Power Transfer Unit Actuator Motor: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Remove the front Subframe. Refer to: Front Subframe
- Remove the PTU temperature sensor harness bracket.
Torque: 97 lb.in (11 Nm)
- Remove the heat shield retainer and position aside the heat shield.
Torque: 89 lb.in (10 Nm)
- Remove and discard actuator motor bolts. Remove the actuator.
Torque: 97 lb.in (11 Nm)
- Remove and discard the actuator motor seal.