LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> Nautilus Base, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - 2.7L ECOBOOST (238KW/324PS) (2 Of 2)) >> Removal And Installation >> Valve Cover RH >> Removal

Valve Cover RH: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
    1. Remove the nut.
    2. Remove the bolt.

    • Remove the engine appearance cover.

    • If the engine appearance cover stud bolt is loosened or removed, it must be installed/tightened.

      Torque: 62 lb.in (7 Nm)

    GFD426595Courtesy of FORD MOTOR COMPANY
  2. Remove the following items:

    1. Refer to: Air Cleaner Outlet Pipe RH 2.7L EcoBoost .
    2. RH charge air cooler intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe 2.7L EcoBoost .

    1. Disconnect the PCV tube quick release couplings and remove the tube. Refer to: Quick Release Coupling 2.7L EcoBoost .
    2. Disconnect the throttle body electrical connector.
    GFD426654Courtesy of FORD MOTOR COMPANY
  4. Detach the engine wiring harness retainer.
    GFD426928Courtesy of FORD MOTOR COMPANY
    • Disconnect the engine wiring harness electrical connector and retainers.

    • Detach the vacuum tube and coolant tube retainers.

    GFD426658Courtesy of FORD MOTOR COMPANY
    • Disconnect the TC vacuum supply tube. Use the General Equipment: Hose Clamp Remover/Installer

    • Detach the vacuum tube retainers.

    GFD426659Courtesy of FORD MOTOR COMPANY
  7. Remove the RH coil-on-plugs. Refer to: Ignition Coil-On-Plug 2.7L EcoBoost .
  8. Loosen the fasteners and remove the valve cover.
    GFD426661Courtesy of FORD MOTOR COMPANY
  9. Remove and discard the gasket.

    • Clean the valve cover gasket groove with soap and water or a suitable solvent.

    GFD426662Courtesy of FORD MOTOR COMPANY
  10. Inspect the spark plug seals. Remove any damaged seals using the special tools. Use Special Service Tool: 205-153 (T80T-4000-W) Handle, 303-1247 VCT Spark Plug Tube Seal Remover and Installer.
    GFD426663Courtesy of FORD MOTOR COMPANY
  11. Clean and prepare the RTV sealing surface. Refer to: RTV Sealing Surface Cleaning and Preparation .
GFD426664Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals