LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKZ Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Cooling - 3.0L ECOBOOST) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
  2. NOTE: Only use the specified material to lubricate the seals.

    Install new condenser fitting O-ring seals.

    Material: Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D (WSH-M1C231-B)

  3. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
scientia non olet · About LEMON Manuals