LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKZ Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Electronic Engine Controls - 3.0L ECOBOOST) >> Removal And Installation >> Oil Pressure Control Solenoid >> Removal

Oil Pressure Control Solenoid: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
  2. Remove the retainers and remove the front underbody splash shield.
    GFD377497Courtesy of FORD MOTOR COMPANY
  3. Disconnect the oil pressure control solenoid electrical connector.
    GFD377586Courtesy of FORD MOTOR COMPANY
  4. Remove the retainer and the oil pressure control solenoid.

    Torque: 97 lb.in (11 Nm)

GFD377587Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals