LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKZ Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine - 3.0L ECOBOOST (2 Of 2)) >> Removal And Installation >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.
  2. NOTE: Make sure the oil pump drive belt teeth are engaged in the crankshaft sprocket prior to installing the oil pump.

    1. Install the oil pump sprocket into the oil pump drive belt.
    2. Raise the rear of the oil pump assembly into the installed position.
    3. Install the oil pump bolts.

      Torque: Stage 1: 89 lb.in (10 Nm) - Stage 2: 45°

    GFD376910Courtesy of FORD MOTOR COMPANY
  3. Install the oil pan. Refer to: Oil Pan  .
scientia non olet · About LEMON Manuals