LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKT Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test BH : DTC U0241:00 >> Pinpoint Test BH : DTC U0241:00

Pinpoint Test BH : DTC U0241:00

  1. BH1 VERIFY THE CUSTOMER CONCERN

    • Ignition ON.

    • Verify that there is an observable symptom present.

    Is an observable symptom present? 

    Yes  GO to  BH2.
    No  The system is operating normally at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.

  2. BH2 CHECK THE COMMUNICATION NETWORK

    • Using a scan tool, perform a network test.

    Does the HCM pass the network test? 

    Yes  GO to  BH3.
    No  REFER to Module Communications Network , The HCM Does Not Respond To The Scan Tool.

  3. BH3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST

    • Check for recorded DTCs from the IPC self-test.

    Is DTC U3003:16 or DTC U3003:17 recorded? 

    Yes  For DTC U3003:16, GO to Pinpoint Test BJ . For DTC U3003:17, GO to Pinpoint Test BK .
    No  GO to  BH4.

  4. BH4 RECHECK THE IPC DTCs

    NOTE: If new modules were installed prior to the DTC being set, the module configuration may be incorrectly set during the Programmable Module Installation (PMI) or the PMI may not have been carried out.

    • Clear the DTCs. Repeat the IPC self-test.

    Is DTC U0241:00 still present? 

    Yes  INSTALL a new interior auto-dimming mirror. REFER to Rear View Mirrors . CLEAR the DTCs. REPEAT the IPC self-test. If DTC U0241:00 is still present, Refer to IPC Guided Routine .
    No  The system is operating correctly at this time. The DTC may have been set due to high network traffic or an intermittent fault condition.
scientia non olet · About LEMON Manuals