LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKC Select, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Cooling - 2.3L ECOBOOST (201KW/273PS)) >> Removal And Installation >> Cooling Module >> Installation

Cooling Module: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse the removal procedure.
    1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.

      Lubricate each grommet with silicone grease.

      Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

    2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
    3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
    GFD393505Courtesy of FORD MOTOR COMPANY
  3. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding 2.0L EcoBoost . Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding 2.3L EcoBoost  .
  4. Evacuate, leak test and charge the A/C system. Refer to: Air Conditioning (A/C) System Recovery, Evacuation and Charging .
scientia non olet · About LEMON Manuals