Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: After installation, make sure the accessory drive belt is correctly seated on all the pulleys.

To install, reverse the removal procedure.
1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.
  
  Lubricate each grommet with silicone grease.
  
  Material
  
  : Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)
2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.

Courtesy of FORD MOTOR COMPANY