LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKC Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - 2.3L ECOBOOST (201KW/273PS)) >> Removal And Installation >> Knock Sensor (KS) >> Installation

Knock Sensor (KS): Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Make sure that the components are installed to the position noted before removal.

    To install, reverse the removal procedure.

    1. NOTE: Lubricating the grommets with silicone grease will aid in the installation of the engine appearance cover, and any future removal and installation of the cover.

      Lubricate each grommet with silicone grease.

      Material: Motorcraft® Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

    2. Position the engine appearance cover onto engine with the grommets aligned with the studs.
    3. Press down on the engine appearance cover at each grommet location to attach the grommets onto the studs.
GFD393505Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals