Pinpoint Test A : Shift Solenoid A (SSA): Notes
WARNING: This page is about a different variant/trim than selected.
Refer to Transmission Controls - 6F50/6F55 for schematic and connector information.
Normal Operation
The PCM applies and releases the various clutches in the transmission by actuating the shift solenoids in the solenoid body. SSA is a Variable Force Solenoid (VFS).
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0750 | SSA | Open circuit in the solenoid or wire harness. |
| P0753 | SSA Electrical | Open circuit in the solenoid or wire harness. |
| P0754 | SSA Intermittent | Intermittent circuit in the solenoid or wire harness open, shorted to ground or shorted to power. |
| P0973 | SSA Control Circuit Low | Short to ground in the solenoid or wire harness. |
| P0974 | SSA Control Circuit High | Open circuit or short to power in the solenoid or wire harness. |
Possible Sources
- Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
- SSA
- Transmission internal wiring harness frame
- PCM