Auxiliary Evaporator Outlet and Inlet Line: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: Loosely connect, but do not tighten the fittings until the rear auxiliary line bracket have been installed and the rear auxiliary line bracket nuts have been torqued.

To install, reverse the removal procedure.
- NOTE: Only use the specified material to lubricate the seals.
  
  Install new gasket seals and O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil. Refer to Climate Control System General Information and Diagnostics .