Front Cover Radial Seal: Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Using the Water Tube Seal Installer, install the front cover radial seal.- Position the front cover radial seal on the Water Tube Seal Installer.
- Position the Water Tube Seal Installer into the engine front cover.
- Using a brass hammer, tap the Water Tube Seal Installer until the front cover radial seal bottoms out.
- 3.
Install the coolant pump. Refer to: Engine Cooling .
- 4.
Install the accessory drive and A/C compressor belt. Refer to: Accessory Drive .