Brake Vacuum Pump: Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.NOTE: Make sure the oil tube filter screen is free of contaminants prior to the installation of the pump or damage to components may occur.
If a new vacuum pump is not being installed, inspect the oil tube filter screen and gasket. Install a new gasket or clean the filter screen as necessary.
- 2.NOTE: If the brake vacuum pump is not secured within 10 minutes of sealant application, the sealant must be removed and the sealing area cleaned with metal surface prep. Failure to follow this procedure can cause future oil leakage.
Apply an 8 mm (0.314 in) bead of the specified RTV silicone as shown.
- 3.NOTE: Manually align the brake vacuum pump drive key with the camshaft slot before installation.
Install the vacuum pump and the 3 bolts.
- Stage 1: Tighten in the sequence shown to 10 Nm (89 lb-in).
- Stage 2: Tighten an additional 45 degrees.
- 5.
Install the RH fender splash shield. Refer to Front End Body Panels .