Brake Booster Vacuum Sensor
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Relieve the vacuum in the brake booster by pressing and releasing the brake pedal a minimum of 5 times with the engine not running.
- 2.
Detach the vacuum hoses and disconnect the vacuum sensor electrical connector.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Remove the vacuum sensor.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
NOTE:
To allow proper drainage of any moisture, the vacuum sensor must be installed in the same position and orientation as removed.
To install, reverse the removal procedure.