Removal And Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Expedition shown, Navigator similar.

1.

Remove the floor console rear cup holders.

Courtesy of FORD MOTOR COMPANY

2.

Remove the retainers, disconnect the electrical connectors and remove the floor console rear trim panel.

Courtesy of FORD MOTOR COMPANY

3.
1. 1.
  
  Disconnect the PATS antenna electrical connector.
1. 2.
  
  Remove the screws and the PATS center antenna.

Courtesy of FORD MOTOR COMPANY

4.

To install, reverse the removal procedure.