Seat Backrest Heater Mat: Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not reinstall any heater mat after removal. The adhesive will not adhere correctly to the foam pad causing it to bunch up or shift out of place. A new heater mat must be installed. Failure to follow this instruction can result in seat component damage and system failure.

1.

Remove the seat backrest cover. For additional information, refer to Seat Backrest Cover - Second Row, 40 Percent .

2.

Route the heater mat wiring harness from the seat.
- Note harness routing for correct installation.

3.

NOTE: Do not use a razor knife or other sharp tool to separate the heater mat from the foam pad. Damage to the foam pad may result. Install a new foam pad if torn or burned.

Carefully peel the backrest heater mat from the foam pad and discard.
- Only a thin layer of foam should peel off with the adhesive.

4.

If burned or torn, remove and discard the backrest foam pad.