Seat - Second Row, 40 Percent: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

1.

Position the seat in the vehicle.
- Align the 2 locator pins to the floor holes.
- Press downward and lock the latch feet to the floor.

2.

Install the 2 seat-to-floor front bolts.
- Tighten to 40 Nm (30 lb-ft).

3.

Install the seat-to-floor bolt front cover.

4.

Using an appropriate tool, push the shipping pin fully inward to unlock the seat from the E-Z entry position.

GFD137590

Courtesy of FORD MOTOR COMPANY

5.

Release the seat to the E-Z entry position.

6.

Install the 2 seat-to-floor rear bolts.
- Tighten to 40 Nm (30 lb-ft).

7.

If equipped, connect the electrical connector and separate the wire harness from the seat.

8.

Install the seat-to-floor rear bolt cover.

9.

Check the seat for correct operation.
- With the seat in the upright or the load floor position, both latch feet must lock to the strikers.
- When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.