Seat - Second Row, 20 Percent: Installation

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The seat-to-floor bolts must be tightened in the sequence described in this procedure.

1.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the seat in the vehicle and align the locator pins to the holes in the floor.

2.

Fold the LH and RH seats to the E-Z entry position.

3.

Install the seat-to-floor bolts in the following sequence:
1. 1.
  
  Install the RH seat-to-floor rear bolt.
  - Tighten to 40 Nm (30 lb-ft).
1. 2.
  
  Install the LH seat-to-floor rear bolt.
  - Tighten to 40 Nm (30 lb-ft).
1. 3.
  
  Install the 2 seat-to-floor front bolts.
  - Tighten to 40 Nm (30 lb-ft).
1. 4.
  
  Install the 3 right and left side seat-to-floor bolts (note, shoulder bolts do not tighten to seat brackets).
  - Tighten to 40 Nm (30 lb-ft).

4.

Install the 2 seat-to-floor rear bolt covers.

5.

Install the 2 seat-to-floor front bolt covers.

6.

Install the left and 2 right side seat-to-floor bolt covers.