LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seating System) >> Disassembly And Assembly >> Seat Cushion - Second Row, 20 Percent >> Disassembly

Seat Cushion - Second Row, 20 Percent: Disassembly

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For parts identification and locations, refer to Seat - Exploded View, Second Row .

  1. 1.

    Remove the seat backrest. For additional information, refer to Seat Backrest - Second Row, 20 Percent .

  1. 2.

    Remove the 2 screws and LH side shield.

  1. 3.

    Remove the nut and safety belt buckle.
    • To install, align the anti-rotation tab.
      • To install, tighten to 55 Nm (41 lb-ft).

  1. 4.

    Release the cushion cover front J-clip.

  1. 5.

    Remove the 2 riser-to-cushion frame bolts and cushion frame.
    • To install, tighten to 30 Nm (22 lb-ft).

  1. 6.

    Release the hook-and-loop strip and remaining cushion cover J-clips.

  1. 7.

    Remove the cushion frame from the foam pad and cushion cover.

  1. 8.

    NOTE: Use care when separating the seat cushion cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat cushion foam.

    Release the hook-and-loop strips and invert the cushion cover to the row of hog rings.

  1. 9.

    Remove all hog rings and cushion cover.

  1. 10.

    To assemble, reverse the disassembly procedure.
scientia non olet · About LEMON Manuals