Parking Brake Shoe Adjustment

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

Special Tool(s)

Courtesy of FORD MOTOR COMPANY

Brake Adjusting Gauge 206-D002 (D81L-1103-A) or equivalent

1.

NOTE: Make sure the parking brake is fully released.

Using the release handle, release the parking brake control.

2.

Remove the rear brake disc. For additional information, refer to Rear Disc Brake .

3.

Using the Brake Adjusting Gauge, measure the inside diameter of the drum portion of the rear brake disc and set the locking screw.
- Record the measurement.

Courtesy of FORD MOTOR COMPANY

4.

Place the Brake Adjusting Gauge over the widest diameter of the parking brake shoes.

Courtesy of FORD MOTOR COMPANY

5.

Adjust the parking brake shoe clearance to 0.45 mm (0.02 in) less than the inside diameter of the drum portion of the rear brake disc.
- Rotate the parking brake shoe adjuster to achieve the correct parking brake shoe-to-brake disc clearance.

6.

Install the rear brake disc. For additional information, refer to Rear Disc Brake .

7.

Test the parking brake for normal operation.