LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Automatic Transmission - 6R80) >> In-Vehicle Repair >> Shift Solenoids (SS) >> Removal

Shift Solenoids (SS): Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

  1. 1.

    Remove the main control. Refer to Main Control .

  1. 2.

    Remove the 6 long bolts from the molded leadframe.
GFD136069Courtesy of FORD MOTOR COMPANY

  1. 3.

    Carefully separate the molded leadframe from the main control assembly.

    1. 1.

      Molded leadframe.

    1. 2.

      Main control.
GFD136070Courtesy of FORD MOTOR COMPANY

  1. 4.

    If equipped, remove and discard the foam strip seal.
GFD136071Courtesy of FORD MOTOR COMPANY

  1. 5.

    Remove the 8 solenoid bracket bolts and the solenoid bracket.
GFD136072Courtesy of FORD MOTOR COMPANY

  1. 6.

    NOTE: A VFS is calibrated from the factory and are not all the same. To replace a VFS, match the replacement solenoid nozzle color and the band number with the original solenoid or harsh/erratic shifts, harsh/soft engagement or damage to the transmission can occur.

    If replacing more then 1 solenoid, number the solenoids and number the main control solenoid ports to correspond to the solenoid. Pull the solenoid (s) out of the main control valve body.

GFD136073Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals