LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Automatic Transmission - 6R80) >> In-Vehicle Repair >> Output Shaft Seal >> Removal

Output Shaft Seal: Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. 1.

    With the vehicle in NEUTRAL, position it on a hoist. Refer to Jacking and Lifting .

Rear Wheel Drive (RWD) vehicles 

  1. 2.

    Remove the rear driveshaft. Refer to Driveshaft .

  1. 3.

    Remove the stakes from the output shaft flange retaining nut.
GFD136057Courtesy of FORD MOTOR COMPANY

  1. 4.

    NOTE: The output shaft flange retaining nut has been staked to prevent it from coming loose. Prior to removing the nut, remove the stake to prevent damage to the output shaft.

    Remove and discard the output shaft flange retaining nut.

GFD136058Courtesy of FORD MOTOR COMPANY

  1. 5.

    Remove the output shaft flange seal and the output shaft flange.
GFD136059Courtesy of FORD MOTOR COMPANY

  1. 6.

    Remove and discard the output shaft seal.
GFD136060Courtesy of FORD MOTOR COMPANY

Four-Wheel Drive (4WD) vehicles 

  1. 7.

    Remove the transfer case. Refer to Transfer Case .

  1. 8.

    Using the Input Shaft Oil Seal Remover and Slide Hammer, remove the output shaft seal.
GFD136061Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals