LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2018 >> MKZ Select, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 593 (Information Center - Instrumentation, Message Center, And Warning Chimes) >> Description And Operation >> Warning Chimes >> System Operation >> Network Message Chart

Network Message Chart

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

Module Network Input Messages - IPC 

Broadcast Message Originating Module Message Purpose
Belt-Minder ® disable request confirmation RCM Input used to confirm enabling or disabling of the Belt-Minder ®.
Belt-Minder ® level request RCM Input used to control the Belt-Minder ®.
Brake chime request ABS module Input used to control the service AdvanceTrac ® warning chime.
Driver door ajar BCM Input used to control the door ajar warning chime and the ignition-engine on warning chime.
Driver rear door ajar BCM Input used to control the door ajar warning chime.
Engine speed PCM Input used to control the ignition-engine on warning chime.
Headlamp on warning indicator BCM Input used to control the headlamps on chime.
Ignition status BCM Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting.
Key in ignition warning indicator BCM Input used to control the key-in-ignition warning chime.
Liftgate ajar BCM Input used to control the door ajar warning chime.
Memory feedback request DSM Input used to control the memory feedback confirmation chime.
Parking brake chime BCM Input used to control the parking brake warning chime.
Passenger door ajar BCM Input used to control the door ajar warning chime.
Passenger rear door ajar BCM Input used to control the door ajar warning chime.
Perimeter alarm chime BCM Input used to control the perimeter alarm chime.
Restraints indicator request RCM Input used to control the airbag warning chime when a fault in the airbag indicator LED exists.
Safety belt chime request RCM Input used to control the chime function of the Belt-Minder ® and the safety belt warning chime.
Transmission gear position PCM Input used to control the ignition-engine on warning chime.
Turn signal command BCM Provides combined messages to control the RH -LH and hazard turn chime tone (tick-tock).
Turn signal switch status BCM Input used to control the turn signal left on chime.
Vehicle speed PCM Input used to control the door ajar warning chime.