Roof Opening Panel Weatherstrip: Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Place a new weatherstrip into position on the glass assembly, with the splice (seam) on the passenger side.
- 2.
Starting with the corners, push the weatherstrip into position. Continue pushing the weatherstrip into position around the glass assembly until complete. Use a plastic or rubber hammer if necessary.
- 3.
Install the roof opening panel. For additional information, refer to Roof Opening Panel Glass .
- 4.
Align the roof panel. For additional information, refer to Roof Opening Panel Alignment .
- 5.
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .