Temperature Blend Door Actuator - Driver Side: Removal

WARNING: This page is about a different car, the 2017 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the heater core and evaporator core housing. Refer to Heater Core And Evaporator Core Housing .

2.

Remove the floor duct screws and floor duct.

Courtesy of FORD MOTOR COMPANY

3.

Remove the driver side temperature blend door actuator.
- 1.
  
  Disconnect the temperature blend door actuator electrical connector.
- 2.
  
  Remove the temperature blend door actuator retainers.
- 3.
  
  Remove the driver side temperature blend door actuator.

Courtesy of FORD MOTOR COMPANY